Nina Alyssa is the owner of Angelic Alchemy, in the mystical land of Sedona, Arizona.
She is creating a safe space for others to explore their inner depths of untapped potential from the comfort and safety of their own homes!
Enjoy the incredible benefits of light coloring and reflective journaling inside this ‘Sacred Awakenings – Coloring Journal Series’..Unlock unlimited possibilities for self-care, reflection, and inspiration, as you journey deep… volume by volume, page by page…
Here is a fun craft that will put a smile on your face and your pets. I have fostered 4 doggies that are my babies. Polly, Lucee, Hazel, and Betty. Each one with its own personality. My daughter saw a painting a dog did and showed it to me and I immediately said, “YES we Must do this!”
We choose to use canvas, you can do this on any media you would like. First I put blobs of paint on the canvas.
We first put down a blue plastic table clothe on the floor of our laundry room. Next, we put the canvas’ with paint blobs & swirls onto the plastic table cloth. Then we put Saran Wrap over the painting enough to tape it to the blue table cloth on all four sides. If you have doggies who love treats and are aggressive eaters, I suggest using more tape.
Take peanut butter and put globs of it on top of the plastic above the globs of paint. I also put shredded cheddar cheese on top. You can use any food that your doggie likes and is safe for them to eat.
Here is the Finished Project!
Once the dogs were done eating we took the saran wrap off the canvas and put in the garage to dry. Drying will take about 48 hours.
If you look closely you can see that each doggie has signed their painting.
Not bad for a first time!
I’m using a stick to help push the paint over the white canvas. You can also use straws to blow the paint. As you can see a lot of paint goes off of your canvas. I like to take my canvas and dip the sides into the excess paint. You can also dip the actual canvas onto the excess paint if you have a white spot.
Thank you for visiting and
HAPPY CRAFTING!
Thank you for watching and come back tomorrow for another great pour technique! Happy Crafting!
With Frisbee Pour, you never know how it’s going to turn out. I guess that is the fun of it! Above is my after photo and to the left is my before photo! Of course, glitter is added at the end!
I think she is ready! 1, 2, 3, Frisbee! Throw your canvas like a frisbee! Run after it and check it out. If you want to throw it again you can!
Funny Story: As I was showing my great-nieces how to do this project, I went first. I threw my frisbee canvas right into our wooden arbor and paint splatter all over it and the squirrel feeder and birdhouse. We did have a good laugh and after picking the birdseed off of it I threw it one more time and love it!
Thanks for watching/learning. I will be doing another pour tomorrow.
With the weather being nice and kiddos bored this is not only a great craft but also there is really no wrong or right way and each one is so unique!
I am a big fan of Rainbows, and EVERYTHING COLORFUL. In this quick tutorial I will show you how easy it to to complete this Love/Rainbow Wreath!
If you made the 4th of July Clothespin wreath a few days ago you will remember that we cut the wire wreath into two pieces and had leftover clothespins. (If you didn’t look at it, you might want to go back and take a quick look before starting this project) Then I attached the clothespins by clipping them on to form my rainbow.
Here you can see I added the word “love.” Wood words can be found at most craft stores! After spraypainting love and letting it dry I then took Red craft wire and put around the frame and then the word. I did add a little dot of Hot Glue to make sure it stayed in place. (A side note – Did you know Craft Stores sell colored wired during the Christmas Holidays and because it is considered “holiday” it goes on sale. After Christmas when the Craft Stores start marking down items to 75% – 90% is when I go shopping! This “Red Christmas Wire” is just a strong as the typical green wire in the artificial floral department of the store.) Next, I had my very talented and strong hubby cut the wire wreath at the ends. (I could have done it but it is important to let them feel good about helping)
Everyone who knows me knows I am a HUGE FAN OF GLITTER! When doing craft projects I always prefer to use FINE sized glitter.
I like to use these fairy lights the best. The battery outlet is very slim and easy to glue if need be. There are many different kinds of fairy lights so it just comes down to preference. With this project, I felt this was the best choice. I purchased these from Amazon in bulk. The Crafty Mercantile has fairy lights for sale in CG.
I know that these bottles are going to be outside. (Making for a friend) I like to use Loctite Stik’N Seal. Outdoor Adhesive. This glue dries clear and pretty fast. It does have a slight odor but it won’t glue your fingers together!
For this craft, I’ve been asked by a friend to use her Jack Daniel’s bottles. Because I know these are going to be outside, I went over all of the labels with Mod Podge to help seal them.
The photo to the left shows other ways you can make lighted bottles. Number 1 & 2 show how I drilled a hole in the back of the glass then glued the battery pack under the bottle. (Be sure you glue the battery pack with the battery side on the bottom so you can change out the batteries!) Photo 3 is the trending way to display fairy lights. This is a faux cork that has batteries in it and you just put it on the top of your bottle. If you plan on putting decor like fake or real flowers in your bottle then you can do the same as photo 1 and drill a hole in the bottom back of the glass bottle. The trick to drilling a hole in the glass without breaking it is to first get a glass drill bit. They have them at our local hardware store and Bi-Mart. Next, you want to put your bottle under running cold water while you drill. It really is that simple.
For this part you want to drop the lights into the bottle leaving about 1.5 inches out of the bottle. Take the wire and wrap it loosely around the upper neck of the bottle and slip the battery pack under the wire and pull slightly to make it tight. Next, you will take a glue dot and put on the inside of the neck of the bottle to hold secure. Drop in the battery pack and slide the switch to on!
You can decorate any way you would like, or not at all! I used glass gems that you can find and the Dollar Tree or any craft store. Don’t forget to look at thrift stores as well. If you can glue it you can decorate it on these bottles! In this case, I had 5 bottles to do, and each one I decorated a little bit differently.
Paint Splat is an activity that can let kids release some frustrations, or can be a game, or a combo of both! I love this one not only because it is inexpensive and all ages can participate, but it also creates laughter!
A few things before you watch this instructional video. I was going to talk and give a play by play but the weather is so nice that there are always dogs barking and lawnmowers in the background. So I tried it with subtitles!
Summer is here and it’s time to start decorating with RED, WHITE & BLUE!
I’ve always loved decorating for EVERY holiday. The 4th of July is really fun to decorate because you spend a lot of time outside and I love YARD ART! For you Pinterest addicts I know you have seen this wreath before and probably have it saved in one of your boards. I did too. I have a board titled, “To Make Soon.” I laugh every time I save something to this board. Ever since Covid-19 began I decided to look at this board and try to make something from it as much as I can. Well, I am happy to say I can now scratch Clothespin Wreath of my list!
(If you have seen my other blogs you can see I am trying to see which way to blog “how-to” crafts are the easiest for you guys! Feel free to comment and let me know which format you like the best. I want all my “how-tos” to be stress-free and easy for all levels of crafters. )
Photo 1. shows you that you need to clip the wire wreath in 1/2. Photo 2. you will see you now have 2 separate rings. (looks like a snowman project will be in order later this year.) Photo 3. shows you that you need to cut off any extra hanging wire pieces. Photo 4. This is the fun part. MATH! This is where your littles can help you figure out how many Clothespins you will need.
Now that you have counted how many Clothespins it will take to make your wreath separate them in 1/2 and then take some of them and move to make the “blue” section. I used 1 section + 5 so 15. Shown in Photo 6. Also, in Photo 6 you will see that they are separated from the others in that row. That is because we are going to spray that entire row with white paint but want to keep the blue ones separate so we don’t have to move them later. I put a large piece of wrapping paper in between the two sections so I could spray both colors at the same time and have less wait time. Also, you can see I put the clothespins on a large box I had in my recycle pile for easy painting. Now if you would like to torture your kiddo you can have them paint each one by hand. Maybe you need time to sneak off and have a nice glass of Reisling or a few Fireball shots! (I don’t judge on this blog, you do what you need to do to survive!)
Now the fun step! Photo 9 shows star stickers on the white clothespins. This can be a reward for your little one after hand-painting all the clothespins or leaving you alone while you secretly finish off your 2nd glass of wine. Remember: The only section we are painting blue is the section shown above in Photo 6. Once Paint is dry peel off the star stickers. (Photo 10.) How cute is that?
As you can see in Photo 11 above, you just start clipping your clothespins in a pattern. I found that 3 worked best. Of course, the kiddos will be a great help at this part! In Photo 12. I flipped the wreath over so you could see the backside. You can see that the clothespins are at different lengths and the pins are clipped only on the first wire row which is the most inner wire, then the pins lay on top of the outer row of the wireframe. My Wireframe only had two rows after we had cut it. Now we get to decorate! Add a Garnish! In Photo 13. I show a country rustic heart, and in Photo 14 a fun Sparkly Bow! Can you guess which one I choose for mine? This is really a simple craft to do and you can color the clothespins for any holiday or theme you choose!